Structural Forces on a Hull – Part 2

When a force is applied the hull will either accelerate to some sort of equilibrium speed, or, if restrained, it will move internally by compressing or stretching. Although a force can only produce tension, compression, and shear, it is convenient to think of loads as being applied in 5 ways: tension, compression, shear, torsion and…

Read More

Wave Action and Structural Forces on a Hull

The most significant forces a vessel will be loaded with are those arising from sea conditions. There are Six degrees of motion — surge when the boat accelerates forwards, as in down a wave; roll, as in rocking from side to side; pitch, which is when the boat is tipping forwards around its centre of…

Read More

Marine Grades of Aluminium and what Welding Wire to use – Part 2

Below is the table showing the grade of aluminium and the correct welding wire in each case. Series:    Alloy Element:                        Filler Wire: Max Tensile Strength    1000         None 2000         Copper 3000         Manganese 4000         Silicon                   …

Read More

Marine Grades of Aluminium and what Welding Wire to use – Part 1

The principle marine grades of aluminium are: Plate and Section Wrought: The ‘marine grades’ are the 5000 and 6000 series. Most plate and sheet is made from 5000 alloys, magnesium is the principal alloying element and is more effective than manganese in improving the alloy strength. Moreover, the 5000 series alloys have good resistance to…

Read More

Working Metals ‘Annealing/Cold Working’ – Part 3

Annealing is the softening of suitable material by heating and then cooling. In this annealed state it may then be hammered, stretched and otherwise formed, progressing toward the desired final shape, but becoming harder and less ductile as work progresses – so it may be re-annealed periodically as the shape progresses. Annealing is stopped when…

Read More

‘Working’ Metals to Increase Strength – Part 2

To restore an alloy billet to its original workability it is held in the furnace at about 500 centigrade and then kept at 383 centigrade until an even temperature gradient is achieved throughout the piece. This allows the internal structure of the alloy to reorganise and stabilise in a homogenous state. As the metal is…

Read More

‘Working’ Metals to Increase Strength – Part 1

Working (hot or cold): A metal is ‘worked’ if it is taken beyond its yield point. Some can be cold worked (to make the desired shape during construction); others have to be hot worked, partly so they do not crack and partly because the metal is softer at higher temperatures. Pure aluminium has a maximum…

Read More

Annealing Metals and Changes in Structural Properties

Annealing is heat treatment that alters a material to make it more workable. The metal is heated to above its critical temperature, maintained at a suitable temperature, and then cooled in a furnace/insulated space. Annealing can soften material, relieve internal stresses, refine the structure by making it homogenous, and improve cold working properties. Steel if…

Read More

The Four Main Welding Defects

A defect is any flaw that compromises the usefulness of a weld – there are a great variety. Defect causes are: 45% poor process conditions, 32% operator error, 12% wrong technique, 15% incorrect consumables and bad weld grooves. Any defect may result in sudden unexpected failure below the design load or after fewer load cycles…

Read More

Weld Defects and Inspection Techniques

Poor penetration, lack of penetration and excess penetration is usually a result of not achieving a good quality join. All completed welds should be visually inspected under good lighting. A magnifying glass and straight edge may be used. Undercutting can be detected with the naked eye and (provided there is a reverse side) excess penetration…

Read More