Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.

When a force is applied the hull will either accelerate to some sort of equilibrium speed, or, if restrained, it will move internally by compressing or stretching. Although a force can only produce tension, compression, and shear, it is convenient to think of loads as being applied in 5 ways: tension, compression, shear, torsion and flexure. Shear is a set of opposing forces in the same plane.

The relationships between rigidity and shape are quantified by the direction of loading/moment of inertia. Moment of inertia is specifically related to the geometry of the cross-section under load. If the direction of loading can be predicted a shape can be developed that puts structural material as far as possible from the neutral axis. Flexural loading is the most common loading for the hull and deck – Longitudinals prevent the hull from flexing up and down, transverse bulkheads and frames resist hull twisting. Both longitudinal and transverse structures are integrated to produce a strong hull. Transverses support the longitudinals and longitudinals support the transverses.

Another area of high loading is on the bulkheads where longitudinal connect, butt straps and brackets will create problems when not continued through the bulkhead. Unbalanced forces applied to the bulkhead will produce a flexing load on the bulkhead. Wherever any stiffening member such as bulkheads, ribs, mast supports are terminated the load can be gradually transmitted through the rest of the structure by distributing it over as much area as possible to reduce stress concentrations.