Planning Hull – Spray Rails

In high-speed powerboat hull geometry, spray rails play a critical and important feature that deserves attention. A planning hull is designed to generate lift as speed increases, allowing the vessel to rise onto the water surface and reduce its wetted area. Spray Deflection – Spray rails help redirect water away from the hull sides, reducing…

Read More

Froude Number (Fr) v Reynolds Number (Re)

The Froude number (Fr) and Reynolds number (Re) are both used to describe fluid behaviour but govern different types of flow forces. The core difference is the Froude number focuses on gravity forces (dominant in open channels and waves), while the Reynolds number focuses on viscous (friction) forces (dominant in pipes and boundary layers/submerged bodies).…

Read More

Horse Power to Boat Speed 

Engine power cannot directly tell boat speed because hull resistance, gear ratio, propeller pitch, RPM and slip all affect the final result. For a geared system, Propeller RPM = Engine RPM / Gear Ratio. The theoretical advance comes from Propeller RPM x Pitch, while actual speed is reduced by propeller slip. For speed in knots,…

Read More

Steel Plate Shaping by Line Heating

Plate Bending by Line Heating – Shipbuilding bow and stern shell plates are among the most challenging parts of a hull to form because they require complex double curvature. Line heating provides a controlled method of producing these shapes by using localised thermal expansion followed by permanent shrinkage during cooling. The principle is simple, but…

Read More

When Water Moves by Wind Not Moon

Some estuaries and sounds are nearly sealed off from the Atlantic tide. An average tidal range can have real levels swing, driven by wind instead of the moon. A strong blow can move levels in half a day. Unlike coastal regions where lunar tides dominate, water levels in estuaries and sounds are primarily wind-driven. Traditional…

Read More

Is a clean record a safer vessel?

If decisions increasingly favour the cleanest record, are we rewarding safety — or its appearance? If selection rewards fewer findings, the incentive shapes what becomes visible. It is what gets reported, what gets recorded, how findings are treated, how performance is judged — and how behaviour gradually adapts. This has unintended consequences on certification for ever-cleaner…

Read More

Ideal Battery Test Procedure

Ideal Battery Test Procedure – Test all batteries during pre-purchase surveys. With a bank of 2-4 batteries costing between £250-£600 it is a valuable test. For example: a 12V marine battery has a charge of 12.84V, a Cold Cranking Amps capacity of 570EN and an internal resistance (IR) of 5.07 milli-ohms (mΩ) all leading to…

Read More

U-bolt Installation

Incorrect U-bolt installation continues to appear in inspections. Common finding: U-bolt clamps installed incorrectly with U-bolt pressing on the live part of the wire. This affects mooring equipment condition and correct rigging practices. It matters because incorrect installation: – Damages the load-bearing section of the wire – Significantly reduces strength – Can lead to failure…

Read More

A Premature Opinion – “Buy v Do Not Buy’

Asking for a definitive opinion before the survey report is complete can be misleading — and potentially harmful to the buying decision. A Pre-Purchase Survey is not a simple “BUY / DO NOT BUY” inspection. A yacht needs to be assessed as a whole system, considering: – Hull and structural condition – Moisture and osmosis-related…

Read More

Red Light Wavelength

Ships always have red on the port (left) and green on the starboard (right) despite that fact that the red light travels less distance than green due to having a longer wavelength. This is not a random aberration — it is a safety system based on visibility. Green’s shorter wavelength only travels further in good…

Read More