Length of Scope v Depth of Anchor

When the anchoring depth is known the additional line/chain is called “scope,” so the boat tugs on the anchor at an angle. An insufficient amount of scope is the most common reason why anchors drag. A scope-to-depth ratio of 3:1 is the bare minimum for anchoring in the best of conditions. Setting out 5:1 is…

Read More

Top Ten Factors in Boating ‘Accidents’

The number one statistical factor in boat accidents is operator inattention – It is the primary cause. Not far behind statistically, is operator inexperience. Improper lookout comes third; then excessive speed. Engine(s) or Machinery failure rounds out the top five. The rest of the top 10 are; collision regulations violation (that is – bad navigation),…

Read More

Sober Reading

70 percent of boat accidents are caused by operator error. Inattention is the single greatest cause of accidents. Alcohol is the leading contributing factor in fatal boating accidents,  75 percent of victims drowned, of those 85 percent were not wearing a life jacket. Most accidents occurs in benign conditions—calm water, light wind, good visibility—this is…

Read More

Compass Deviation Card

A one degree compass error means 10 meters off-course in a mile. Reducing deviation begins with locating the compass as far as practical from engines, instrumentation, radios and other metal objects. Electric field interference from current flowing through wires can be determined by switching instrumentation on/off and watching the compass. These electric fields can be…

Read More

Turbocharger Do’s and Do Not’s

Pull off the intake filter, the compressor wheel fins should be sharp/knife like. If rolled or otherwise damaged – get professional help: Rolled blades do not pump as much air and cause an engine to overheat by excessive fuel burning – not enough air to cool the combustion chambers and the engines cooling water system…

Read More

Emergency/Bilge Pump Capacity – Calculation

Four sources of water ingress are: Shaft and/or surface drive steering. Exhausts. Hoses and through-hulls. Damage to hull. At all four locations water enters the boat under pressure, and the pressure increases as the boat is sinking; the exact amount is speculation, but a rough estimate can nevertheless be made using a formula: Flooding rate…

Read More

Serious Sailing! – Most Useful Tools for Repairs at Sea

A comprehensive tool set is key: Standard domestic DIY tools – screwdrivers, a power drill, spanners, wrenches, pliers, Allen keys, a socket set, mole grips, wire cutters, a hacksaw, gaffer tape, a soldering iron, a multimeter, etc. A thorough selection of glues, sealants and lubricants. A glass fibre repair kit and a selection of long…

Read More

5 Safety Equipment for all Yachts

1) A life jacket that must be available ready for use for each person on board, including child sizes. Children under 12 should wear their jacket when underway. Lifejackets to be out of manufacturers packaging as the alloy zips corrode making emergency use difficult. If you tow a skier/wake surfer – a PFD as well.…

Read More

Bilge Pump Capacity Calculation

In the minds of most manufacturers and boat owners, bilge pumps serve as emergency pumps. There are enough holes through the average boat to sink it in minutes. Boat flooding due to poorly maintained through-hull components are consistently a leading cause of insurance claims. Do not assume the manufacturer has sized the bilge pump to…

Read More

Stern Gland/Stuffing Box

The old style/conventional stuffing boxes leak. They are supposed to — that is how they are lubricated and cooled. The knack is to adjust them so they leak 2 – 4 drops a minute when under way; just enough to stay cool, but not so much they become a flooding problem. When stationary they do/should…

Read More