Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.

Pull off the intake filter, the compressor wheel fins should be sharp/knife like. If rolled or otherwise damaged – get professional help: Rolled blades do not pump as much air and cause an engine to overheat by excessive fuel burning – not enough air to cool the combustion chambers and the engines cooling water system can not make up the difference. If you have unusual overheating, check your turbo. Clean/replace the air filter at least once a year.

If you see oil in the intake side of the turbo – get professional help: A turbo spins 40/50,000 rpm – and contact-less labyrinth bearings reduce friction to almost nothing. No-contact bearings use a thin film of engine oil to lubricate the spindle – if the seal on a bearing fails oil will leak in and eventually cause problems.

Let the engine idle for five minutes or so before shutting down: When an engine is shut down abruptly the oil flow through the turbo’s no-contact bearings stops abruptly – if the turbo’s still spinning fast this causes wear on the bearings. Also, the hot turbo can bake the oil left in it creating hard patches on the spindle that prevent the oil lubricating the bearing seals correctly. Let the turbo slow and cool down, before shutting down.

Remove the exhaust elbow: Look for rust in the elbow itself; and look if the turbine has a thin layer of ash/dust from the exhaust, vacuum it out, be careful not to damage the turbine blades. There should not be any oily clumps, rust or moisture – sometimes raw water from the exhaust elbow finds its way back into the turbine, where it causes problems. The turbine blades should be undamaged and fit tightly against the housing, with just enough clearance to let the turbine spin. If something does not look right – get professional help.