Uncategorised
Hoses and Clamps – Part 2
Fuel line standards also specify maximum acceptable tolerances between fuel-line hoses and any unions or nipples to which they are clamped; All unions or nipples require a bead, flare, or serration, but no fuel-line can be installed over a pipe thread; and further require a hose clamp that does not “depend solely on the spring…
Read MoreHoses and Clamps – Part 1
There are usually around 8 different types of hoses onboard, each a specific type; fuel, exhaust, gas, engine water intake, fresh water (hot and cold), waste, water heater, bilge water, gear lube, and blowers. The International Standards Organisation (ISO) sets standards on many of these hose types, to keep boats and boaters safe. Examples of…
Read MoreSeacocks/Valve and Hoses Maintenance – Part 3
Specific maintenance requirements vary for different types of seacock (plug, ball, bronze, Marelon, etc.). Operating the seacock monthly and greasing twice a year is ideal (even “maintenance-free” types). Seacocks without a grease fitting can be lubricated in the water only by following these 5 steps: 1 Close the valve. 2 Pull the hose. 3 Remove…
Read MoreSeacocks/Valve and Hoses Maintenance – Part 2
Installation mistakes to keep an eye out for include the use of plastic to metal joints. These materials have different expansion and contraction rates which result in plastic fittings cracking or splits. Other installations use a short piece of pipe or hose between the seacock and through-hull, which is a failure point inside the hull…
Read MoreSeacocks/Valve and Hoses Maintenance – Part 1
Seacocks to be inspected and valve handles exercised monthly to ensure proper operation and to heads-up potential problems. Begin with a visual inspection; issues such as leaks, broken hose clamps, corrosion, damaged or missing components usually handles. If part of a bonding system, check connections are tight and terminals corrosion free. Probe any backing blocks…
Read MoreThe Dreaded Marine Toilet Malfunction – Part 2
Common Problems and Solutions Lack of water into, or waste out, of the bowl. Check pipe hose clamps; check pump plunger O-rings. It is a suction pump arrangement so air-leaks prevent the pump working. Smell caused by waste sitting in low spots in hoses and then venting from holding tank into cabin spaces. Ensure hoses…
Read MoreThe Dreaded Marine Toilet Malfunction – Part 1
A marine toilet is a relatively simple apparatus to repair. There are just a handful of manufacturers; most have replacement parts for purchase. Repair is generally a matter of getting dirty. Here is how it works. Water is drawn into the toilet by pumping the plunger. This creates a vacuum that draws seawater in…
Read MoreBilge Pumps – Wiring Standards
A slow rate of flooding should be managed by a fitted bilge pump. The connected float switch is intended to automatically activate the pump. The pump, wiring, and switch will then be partially submerged at the time of flooding. Electrical connections without protection from water or moisture may prevent the pump from working. Bilge pumps…
Read MoreAlternative Metals for Anodes
Anodes react in water and dissolve. The metal corrodes because of naturally occurring electro-chemical reactions. Anodes have an attractive electro-chemical voltage range so corrosive reactions concentrate on the anode. While zinc is an effective anode and small amounts of zinc are essential for human health, in higher concentrations it can cause real problems. Prolonged exposure…
Read MorePropeller Rotation
Propeller directionality/spin applies to how the blades are orientated. A right-hand propeller rotates clockwise, most recreational boat propellers have a right-hand prop. On twin engine boats propellers rotate in different directions for steering reasons. If they went the same way there would be added torque to either port or starboard. As the prop rotates it…
Read More