Isophtalic and Ortophtalic Resin Characteristics

Isophtalic polyester resin has several advantages over the commonly used ortophtalic polyester resin. higher elasticity and higher elongation before breaking. Thus a better matching of the elasticity inherent in glass fibres and therefore a better usage of the strength potential of the fibres. The isophtalic resin elongates to approximately three times that of orthophtalic polyester.…

Read More

Sandwich v Panel GRP Construction

Sandwich construction has the following advantages to traditional solid panel GRP construction. 200-300% increase in panel stiffness; better insulation, less condensation and noise. Strength of sandwich laminate will not decline as fast as traditional GRP lay-up due to less panel flexing; superior strength to stiffness and very low weight. The lighter the yacht the more…

Read More

Battery Info – Part 3

Some lithium batteries dual-purpose – both cranking and deep cycling. They have the ability to act as a source of power for low consumption circuits and electronics, and also provide power to start the engine. Starter motors are designed to only pull as much power as is needed when being cranked so that the battery…

Read More

Battery Terminology – What Does It mean? Part 2

Cold cranking amps (CAA) tell you how many amps/intensity are produced during 30 seconds at minus 18 centigrade. Cold weather simply cases batteries to be less efficient and slow down. A good yard-stick is you need 1 amp per 15cc of engine capacity – i.e 150cc engine = 10 amps: 1.5 litre engine 100 amps.…

Read More

Battery Terminology – What does it Mean? – Part 1

Cold cranking amps (CCA) is the measure of amps available to crank/start the engine at minus 17c.  Marine cranking amps (MCA) is used to measure the amps produced at 0 degrees celsius which is freezing point for water. MCA is related to boat batteries; MCA amps are higher than CCA amps because batteries produce more…

Read More

RIB Maintenance – Part 2

Undamaged inflatables lose air a 10% loss over 24 hours is considered normal. Keep the valves clean from sand, grit, salt crystals, weed etc. If you have a puncture patch it with the kit from the same manufacturer. Clean area with solvent to clean away any petrol, diesel, wax on the tubes – then patch.…

Read More

RIB Maintenance – Part 1

RIB’s are the workhorse onboard. Maintaining an inflatable begins by cleaning it with mild soap and fresh water (ideally after every use) then rinse it and dry it before putting back the floorboards, seats etc. The rigid parts you treat as you would any fiberglass boat — wash and wax once or twice a season…

Read More

Hoses and Clamps – Part 5

Toilet-discharge hose generally labeled ‘sanitation hose’ is an impermeable (including smell) type. It is available in PVC and Rubber; the choice depends on a few factors: PVC sanitation hose is specially compounded from a high-density material with greater than normal wall thickness to increase resistance to moisture absorption. As a result, it is stiff and…

Read More

Hoses and Clamps – Part 4

Engine water hoses are heavy duty. They run from the seawater through-hull valve to the water pump, then to the heat exchanger, up to the engine’s exhaust. It may appear easier (and cheaper) to install a light duty rubber hose to connect the through-hull valve to the raw-water pump, plumb in a siphon break, and…

Read More

Hoses and Clamps – Part 3

Exhaust hose, double-clamped – prevents water and, more importantly, fumes from escaping. Exhaust hose is a heavy-duty fabric reinforced construction, either with or without wire as extra reinforcement. The marine standard is that the hose is required to be able to withstand total loss of cooling water (with engine at full power) for two minutes…

Read More