Battery versus Diesel Power

Away from shore 220v requirements can come from a generator or an inverter that draws on the battery. Even small generators can supply the high in-rush current required to start air conditioners. However, they can be costly – typical generators suitable for an air conditioned 10meter boat will cost around £4000. Inverters silently convert the…

Read More

Sources of Leaks – Gas

Gas installation has to have a “no leak” policy. The best way to check is to conduct a leak down test on a regular basis. Fit a pressure gauge on the cylinder side of the pressure regulator – its primary purpose in life is to help test the system for leaks. With the gas valve…

Read More

Sources of Leaks – Exhaust and Fuel

Exhaust system leaks are serious, not only because of the potential engine failure, but also due the introduction of deadly CO into the interior of the vessel. Dry exhaust leaks (between manifold and block) can be found by feeling for escaping exhaust or holding tissue paper near the suspected area and watching for movement. Wet…

Read More

Sources of Leaks – Bilges

The first step in locating a non-obvious bilge leak is to dry the section of bilge where the leak seems to be coming in, then place folded paper towels fore and aft of the area. Then check to see if either towel is damp. If one of the end is wet, then the adjacent bilge…

Read More

Sources Of Leaks

The sudden appearance of water could be anything – patience, observation, a good sense of smell, colour and consistency of the leaked fluid itself point to likely sources, coolant and transmission fluid leaks being a good example. First determine whether the water is salt or fresh. If fresh the drinking water system is the likely…

Read More

Propeller Construction Materials

Aluminium, stainless steel, or composite glass-reinforced plastic are the choices and whether to go for a solid single piece casting or a rubber bushed hub, and lastly the number of blades required. Solid props without a splined rubber bush down the centre of the hub, are predominantly for competition and are to be avoided because…

Read More

Which Anodes to Choose

The size of the anode is a function of how many square meters/feet of metal are being protected. You should also fit shaft anodes as long as the engine and susceptible boat fittings are bonded. Making sure metal fittings are protected against both galvanic and stray current corrosion is the main preventative maintenance regime onboard.…

Read More

Lost Rudder! How to set up a Drogue

For the drogue – a 2 x 8meter rope (mooring lines) bridle attached to each of the stern mooring cleats, then a 12meter warp, then 4m of chain with an anchor and a fender attached at the end, then another 4m warp with a fender, another 4m warp and fender, another 4m of chain and…

Read More

Common Types of Stainless Steel Corrosion

Crevice Corrosion:  a problem with stainless steel when used in oxygen starved areas where chlorides pit the stainless surfaces and lacking oxygen to ‘re-stainless’ the surface corrosion continues. This corrosion is most common under bolt heads. Pitting: Stainless that has its protective coating penetrated in a small spot becomes an anodic, while the coated part remains…

Read More

Hull Identification Number (HIN)

HIN is a 12 character number that identifies any boat. It is easy to decipher and tells you who and when the boat was built. HIN numbers were introduced in the EU in 1998. Some boats in the EU did use HIN numbers prior to that 1997/6 and most American boats had a HIN by…

Read More