Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.

Gas installation has to have a “no leak” policy. The best way to check is to conduct a leak down test on a regular basis. Fit a pressure gauge on the cylinder side of the pressure regulator – its primary purpose in life is to help test the system for leaks.

With the gas valve in the galley turned on, and hob and oven valves in the off position pressurise the system, then close the tank supply valve, leaving the galley valve open.

Observe the pressure gauge reading – the pressure should remain constant for at least three minutes. A drop in pressure indicates a leak, at which point the entire system is to be checked with a leak detection fluid or detergent solution to locate the leak (test solutions must be non-corrosive and non-toxic).

The leak must be found and repaired then re-tested before operating the system. Never use a flame to check for leaks. Never use solutions containing ammonia (present in some soaps and detergents) they can attack brass gas fittings.

After cooking, leave one burner ignited and turn off the gas bottle valve. When the burner goes out close the gas bottle valve — this empties the line of gas and prevents leaking should a burner valve fail to seal.