Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.

Installation mistakes to keep an eye out for include the use of plastic to metal joints. These materials have different expansion and contraction rates which result in plastic fittings cracking or splits. Other installations use a short piece of pipe or hose between the seacock and through-hull, which is a failure point inside the hull unprotected by the valve.

To check a seacock is working properly remove the hose and look through the seacock to verify operation or to spot blockages. If the vessel is on the hard shine a torch into the through-hull from the outside and observe its operation by opening and closing it.

Next, inspect all  hoses, are they the correct type? Marine grade and approved for use below waterline. Are they free from damage, deterioration and each end double clamped with stainless steel? Is there sufficient hose barb ? — otherwise a second clamp will crush or cut the hose! All hose has a limited lifespan considered to be 10 years, regardless of appearance.