Antifouling Paint: What to Choose?

Antifouling paints are all intended to eliminate growth and to get the job done they have biocides in them. There are two basic types of antifouling: hard epoxy paint, and soft ablative paints that slowly self-clean and expose new biocides underneath. There are also many hybrid paints that are semi-ablative, splitting the difference between hard…

Read More

Items Not Included in Survey

Items not Included With the exception of moisture readings of the hull and percussion testing no other non-destructive testing (NDT) measurements are made unless requested (for example ultrasound or plate thickness measurements). The rigging is inspected from deck level. If further inspection is wanted a qualified rigger needs to be appointed to inspect aloft. The…

Read More

Meanings of Some International Signal Flags

Most should know their signal flags by sight (and the meanings from memory). But there are some double meanings. Often the only flags on board can be, C Charlie – (affirmative)  and N November – no (negative), but N + C, or N over C, means – I am in distress. Commonly seen is the blue…

Read More

Seacocks or Ball Valves

A marine valve is required to withstand a 220kg load for a period of 30 seconds – so if you step on one in the engine room it won’t break off and let in sea water. There is some confusion between seacocks versus ball valves. True seacocks have a bronze body holding a tapered plug…

Read More

Engine Cooling Pumps – Impellers

Pump impellers come in two basic categories – high volume low pressure impellers and low volume high pressure impellers. Most engine-cooling pumps have a brass cover plate held on with several bolts with a flimsy paper gasket behind – which usually breaks. Removing the screws and cover plate exposes the impeller. If the impeller has…

Read More

Pump Impeller – Failure

The failure of a rubber impeller is high on the list.  There may be several on any boat – outboard, electric head, pressurised water system, wash-down pump and oil-change system, engine cooling-water pump, and fuel pump. Most pumps use impellers, they can fail for several reasons at any time with consequences ranging from a smelly-mess to…

Read More

Galvanic Isolators

How to protect the boat from galvanic corrosion if the risk is posed by other vessels via shore power connections? In most cases the shore earth wire is connected as a common ground for all vessels and the pontoons themselves. Vessels suffer dramatic and, sometimes, terminal corrosion due to the faulty shore power terminals or…

Read More

Sacrificial Anodes – General Information

As a rule of thumb expect a typical anode to be effective to a distance of 6-7 times its own length. So for an anode that is approximately 150mm long, it should be effective to a distance of about 1 meters in any direction. Sacrificial anodes on a shaft need to be installed so as…

Read More

Effective Anodes – at what cost

An anode’s effectiveness relates to the purity of the metal. Zinc anodes have to be 99% pure zinc to function. Impurities, (iron/lead), greatly reduce any protection. High quality zinc anodes are expensive, for this money the anode will do its job. Lesser quality anodes at a greatly reduced price are cast by melting down old zinc…

Read More

Services Before Pre-Purchase/Insurance Survey

Services Before Survey (1) Accompanied Viewing where I visit the yacht or several yachts with you and provide verbal advice and a report is not issued. (2) Preliminary Survey which is a partial survey as-is (ashore or afloat) with no sea trial and includes a brief verbal or at extra cost a written report which…

Read More