Engine Installation Surveys 3) Outboard Engine Inspections

3) Out board engine inspection typically covers (Stern drive inspection where relevant): Outboard drives are exposed to the elements and as a result – control, steering and ignition systems suffer. The main area of concern is the lower drive unit which turns the drive shaft, this is a heavily stressed part which requires large bearing…

Read More

Engine Installation Surveys – 2) Stern Drive Inspection

2) Stern drive inspection typically covers (Inboard engine where relevant): To satisfactorily inspect a stern drive the vessel needs to be ashore and the drive removed from the boat. Lack of routine inspection is the cause of premature failure of universal joints, gimbal bearings, engine drive coupling, rubber gaiter and bellows. Inside the bellows are…

Read More

Engine Installation Surveys – 1) Inboard Engine Inspection

1) Inboard engine inspection typically covers: External assessment of Propulsion Assembly – engine, gearbox (reduction and clutch), ignition/injection systems, lubrication, cooling system (direct/indirect), exhaust system (wet/dry), steering system, stuffing box/stern gland seal, shaft coupling and bearings, engine control systems and linkages, starting/charging system, electrical installations. The assessment covers safety, access and suitability of the installation.…

Read More

Engine Installation Surveys

Engine Installation Surveys – A detailed external inspection of the engine, associated systems and general installation. Engine installation surveys are specifically tailored for: Inboard Engine; Stern Drives; Outboard Engines; Sail Drive; Jet Drive; Azimuth Thrusters; Volvo IPS).  

Read More

Masts, Spars, Sails and Canvas Work

Masts,Spars, Sails and Canvas Work – Extrusions and fittings inspected for damage and corrosion. Rigging checks – swaging, splicing, mast furlers and reefing systems. Sails unpacked – material condition, stitching and fittings checked.

Read More

Rigging Inspection Sailing Vessels

Marine Engineers Certifying Authority Limited (MECAL) technical notice MTN 25-2 (Rig Inspections Sailing Vessels) requires: Rig 10-15yrs old – Riggers Inspection Report. Complete standing renewal of standing rigging advised at this point. Renewal of wires in pairs over several years acceptable. Rig over 15yrs old – Complete renewal of standing rigging required. I am disappointed…

Read More

Plate Thickness Survey

Plate Thickness Survey – gauges the hull and deck plate condition and provides a representative report and highlights any areas of thinning and wastage. This can be done with or without removing paint layers depending upon surface condition. Results are tabulated and trends of wastage highlighted. A thickness survey is recommended with a pre-purchase and…

Read More

Multi-Echo Ultrasonic Thickness Testing – Steel & Aluminium

Multi-Echo Ultrasonic Thickness Testing permits measurements and usually excludes the need to remove paint or anti-fouling. Different probes allow different thicknesses of measurement. They give good readings with corroded metals and multiple paint layers. Where a structure has been heavily filled or faired readings are obtained from interior surfaces. The results represent thicknesses at specific…

Read More

Ultra-Sound Testing – GRP/FRP & Composites

Ultra-Sound Testing – GRP/FRP & Composites – for the assessment of mechanical and physical properties, and the detection of material defects. Ultrasound can measure for; impact damage, delamination, voids, fibre and resin volume, mechanical strength and condition of the fibre/matrix interface. Ultrasonic testing is non-destructive, it is a most useful test and will reveal the…

Read More

Moisture Testing

Moisture Testing – Using a Sovereign Marine Moisture Meter specifically designed for the taking of moisture readings on GRP laminates. Calibration of the unit is checked before the survey and further checking ensures that the deep and shallow readings have the correct values. Deep and shallow modes indicate the location of moisture in the laminate.…

Read More