Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.

Where deck and above the waterline hull fittings are concerned, brown staining is usually a result of the use of low corrosion resistant 304 or 18-8 stainless alloy and/or exposure to stagnant water.  This alloy is used for 99% of all common fasteners, bolts, screws and nuts.  In the first case, short of replacing the hardware there’s not much that can be done.  In the latter case, however, there is a solution.  If you look closely, what’s often clear about the staining is that it emanates from the perimeter of, or under, the offending hardware.  This is because water becomes trapped beneath the hardware, where it becomes stagnant and thus oxygen-depleted, where it then leads to “activation” of the stainless steel; it begins to corrode.  This phenomenon extends to fasteners as well, if the holes through which they pass in decks, cabins and hulls, are filled with stagnant water they will become active.

The solution involves removal, thorough cleaning, de-waxing, and fully bedding the hardware.  That is, instead of applying bedding compound only to the areas where fasteners pass through, the entire base of the hardware, be it a cleat, port light trim ring, grab rail flange, chock or any other hardware, should be liberally bedded with sealant that will both create a watertight seal and exclude water that could migrate beneath the hardware base.  Exclusion of the water is the key to preventing staining.

In addition to bedding, polishing otherwise rough or irregular stainless steel will minimize surface staining (polishing removes micro-pits where corrosion gets its start).  Avoiding water traps in recesses where (often undersized) fasteners are installed will also aid in prevention of crevice corrosion and staining. Fastener heads should fill the hole and countersink in any hardware, always use the largest screw that will fit, and it should be fully bedded.  Even then, fastener recesses can form water traps which lead to staining.  Using 316 stainless alloy fasteners, as well as polishing fastener heads, will reduce the incidence of staining.