Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.

Fire suppression systems relating to battery installation are usually sized around battery capacity. How much battery capacity largely depends on how it will affect your inverters efficiency delivering the boats onboard loads.

Design rule: to be effective, inverters need access to a battery bank that is 20% as large in amp-hours as the inverter size in watts. This means a 1000-watt inverter should be supported by at least 200Ah of battery capacity.

The rationale behind this rule is that inverters use about 100Ah of electricity for every 1,000-watt-hours of use. So if a 1000 watt-hour were used at its maximum capacity for an hour, it would consume 100Ah. This would discharge a 200Ah battery by 50% if it started out fully charged. This is a recommended minimum: as usual, more battery capacity is better.

Calculating electrical loads: any appliances and electronics have their wattage on a back panel. If only the amp rating is provided, use the following conversion formula: Volts x Amps = Watts. For each appliance, its wattage, multiplied by hours run per day, divided by 10 will approximate the number of amp-hours consumed from your batteries.

If an inverter is going to run a 500-watt load, it will draw around 50A DC. The math behind this rule is as follows: 500-watts AC ÷ 85% efficiency ÷12.5V = 47A DC. Keep two things in mind: 500W is not very much power (think about a small cabin heater that draws 1500W or a large hair dryer that draws 1000W); and 50A is a heck of a lot of DC current use.

Not many DC loads on boats 40′ and under would draw 50A or more for more than a few minutes. Therefore, an inverter frequently becomes the largest DC load on most boats, and may require substantial changes in the Li-ion battery capacity, wiring of the boat, and thus the fire suppression system required to manage an Li-ion battery installation.