Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.
A crack in metal (steel or aluminium) plate or fibreglass matrix can be prevented from spreading (propagating) by drilling a hole at the very end, or just in-front of the crack. The drill hole size does not depend on the length of the crack but the thickness of the plate or matrix. The rule of thumb is three times the material thickness. E.g for 3mm plate the drill size is 9mm+/-. The crack stop hole relieves the stresses placed on the metal and keeps the crack from expanding.
Most cracks propagate from any area of differing stress; a previous hole, a skin fitting or pipe fitting, or from a faulty weld. For very short cracks in any plate/matrix just use a 3mm 1/8″ drill size. If the crack is in a middle of a plate, drill at each end of the crack.