Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.

The most significant forces a vessel will be loaded with are those arising from sea conditions, there are however permanent loads arising from the vessels own weight, large machinery loads, and the weight and pressure of liquids in tanks. Sea loads are – slamming, slapping, bow submergence, passing waves and heeling. The hulls longitudinal loading is produced by the buoyant and gravitational forces upon the hull; the hogging and sagging produce high flexural loading upon the longitudinal supports. In larger vessels this is an important loading factor.

The way a hull moves internally when a force is applied is the key to evaluating the function of the structural components. When a force is applied the hull will either accelerate to some sort of speed, or, if restrained, it will move internally by compressing or stretching. Although a force can only produce tension, compression, and shear, it is convenient to think of loads as being applied in 5 ways: tension, compression, shear, torsion and flexure. Shear is a set of opposing forces in the same plane, it is this ability to bear stress that defines solids, while fluids (including gases) will flow until the shearing stresses are gone. Hogging and sagging produce flexural loading movements. It is this relationship between force and movement that defines how and where structural components are used and located, in order to balance the strength of the vessels shape and its required stiffness.

These relationships between rigidity and shape are quantified by the moment of inertia. Moment of inertia is specifically related to the geometry of the cross-section under load. The stress produced in the part is inversely proportional to the moment of inertia. The higher the moment of inertia, the lower the stress produced under a given load. The moment of inertia increases as a cubic function of the material from the neutral axis. This illustrates that if the direction of loading can be predicted a shape can be developed that puts structural material as far as possible from the neutral axis. Flexural loading is the most common loading for the hull and deck. Consequently understanding flexural behaviour is essential for predicting the location and strength of structural component mechanisms.