Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.
Above waterline and on deck weathering always starts first at discontinuities – corrosion begins at any break in the paint scheme, edges of superstructure, weld beads, stanchion bases, bolt heads, etc. The exposed edges of all plating should be ground smooth and their sharp corners rounded off, additional care is needed to ensure paint thickness at outside corners and raised edges is adequate to manufacturers specifications. Paint thickness is an important factor to the life of the coating. Paint films are not constant in thickness as the paint drains away from sharp corners and raised points. Smooth uninterrupted plates remain rust free for a long time. Weld beads should ideally be ground smooth as should edges of superstructure, etc. Other areas of ‘rust raisers’ are chafe, such as on bollards, or where ropes run or anchor chains rub.
Ultra violet deterioration will take place wherever water is trapped or permits constant puddling and evaporation. The gunwale should not trap water. Stanchions should be set clear of the toe rail so that drainage, cleaning and painting around their bases can occur. Bolt heads and any raised fixtures need special attention to their protective coating.