Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.

A complete fuel gauge system is quite simple – it is easy to test and diagnose. The system is composed of three parts: The gauge itself, the fuel sender, and the wiring between the two. The gauge is dash mounted and powered by the ignition circuit. The fuel sender is mounted inside the fuel tank and rises and lowers with the level of the fuel in the tank, a rheostat measures the float height as an electrical resistance. This resistance is transferred to the gauge via wire and is displayed as a reading on the gauge.

Problems with the guage and wiring can be diagnosed in 3 steps:

1) With power at the gauge (ignition on): Use a DC voltage test meter, measure the voltage at the + (sometimes marked with an ‘I’) and – negative terminals on the back of the gauge. The reading should be the same as the battery voltage. If there is no voltage reading at the gauge, the problem is with the power connection to the gauge itself.

2) Next, test to see if the gauge is reading resistance correctly.

  1. With power to the gauge, run a wire between the negative post on the back of the gauge and the fuel level sender (where the sender wire attaches to the tank top), usually marked with an ‘S’. When this is done, the gauge should read at its lowest setting
  2. With power running to the gauge, remove the sender wire from the gauge completely. The gauge should jump to its highest setting. If both of these are true, the gauge is functioning correctly, and the problem lies in either the sending wire, or in the fuel level sending unit inside the tank.

3) Test the sender wire, by removing both ends (from the gauge, and from the sending unit mounted to the top of the fuel tank) and test for electrical resistance with the multimeter set to Ohms, and probe each end of the wire. The reading should be as close to zero ohms as possible. If the reading is ‘over limit’ or ‘no continuity’ there is a problem with the sending wire.