Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.
Traditional Trim Tabs
Traditional trim tabs use stainless steel flat planes called tabs. The actuators adjust the tabs up and down to counteract with the bow up or bow down. The control panel is marked, bow up or bow down. Many electro/hydraulic trim tab designs are available and some are all-electric option—no hydraulics to maintain.
Maintenance starts with just keeping your mooring lines, fenders and any other engine compartment equipment away from the hydraulic reservoir, consisting of the pump system and the connecting tubing. The total electric systems have the same concern—keep snags from disconnecting the control system wiring.
Outside the boat, regardless of how your boat is stored— stacked, on a trailer, or on the water—you should be able to see the condition of the anode. These pancake-style zincs are easy to judge for zinc degradation, replace them along with other zincs on your boat: the shaft, strut, outboard or stern-drive lower unit.
Another area to maintain is the actuator ram rod or stainless steel piston push rod that deploys the tab and retracts it. The major preventive maintenance tip is to retract the rod mechanism after daily use. If the piston push rod is left extended in the water, then marine creatures will attach to the unprotected rod. This causes the oil seal to wear and leak oil into the sea or allows water into the actuator mechanism.
The most important thing to remember; for example when fishing from astern you may run the boat backward. So be sure to retract or raise the tabs UP or the reverse motion may break off the tab. Some boats install ‘homemade’ stainless cables to prevent overextension and breaking the tabs off. Some tabs even have sacrificial plastic shear pins to avoid pulling the actuator out of the transom.