Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.

Deck hardware such as cleats, chocks and lifeline stanchions, is expensive. High-quality boats use cast stainless, bronze or aluminium. Bronze fittings are easier to maintain if chromed, but can be left natural for a more traditional appearance on retro look boats.

Cleats and chocks should be large enough to handle the size of rope appropriate for the vessel. 15cm cleats (measured from tip to tip) are fine on boats under  7 meters in length, but look for at least 20cm cleats on a 10 meters and 25cm on larger boats. Quality builders install oversize cleats on the foredeck for anchoring.

Check at least one cleat to be sure it is properly through-bolted and backed. You will have to get underneath the deck usually the anchor locker and stern quarter areas are the most accessible. At a minimum you should find large washers and either self-locking nuts or regular nuts with lock washers. Higher quality boats use backing plates to spread the strain over a wide area of the deck.

Railings and lifelines should be at least 60cm tall with stanchions no more than two meters apart. Stanchion bases should be through-bolted in the same manner as cleats. Welded rails are strongest, but built-up installations are acceptable if all parts are bolted together. Tubing should be a minimum of 18mm in diameter.

Decks intended for walking must have some sort of non-skid treatment. Non-skid patterns moulded into the gel coat are acceptable but difficult to clean. Sanded paint is better and patent non-skid material best.