Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.
Stand at the bow or stern where you can look down either side. Use the reflection of the sun or an other light source to assess both the smoothness of the gel coat and the fairness of the hull. Moving your head left or right will “move” the reflection of the light along the hull. A smooth, well-made gel coat will reflect light evenly along the length of the hull. There will be no dull spots or colour changes. A sudden jump in the movement of the reflection indicates an unfair spot on the hull. A typical unfair situation is a hard spot usually caused by improper installation of an internal bulkhead pushing against the hull.
Next, look for print-through of the underlying fiberglass material. This usually shows up as a faint pattern of woven roving which can only be seen with the light at an oblique angle to the surface. Print-through is only a cosmetic defect, but if severe it suggests possible quality control problems in the overall layup and/or thin gelcoat.
Finally, use a metal blade to tap lightly the edges of the chines and the sharp corners where the transom meets the hull sides. Laying up fibreglass matt into these right angle bends is difficult. A sharp rapping sound from the coin indicates the job well done. A dull thud is the telltale sign of a hollow where the laminate has not been pushed up hard against the gel coat.
Use the sun or bright light to check on deck in the same manner as the hull. Tapping an occasional sharp bend or edge in the same manner. Deck mouldings are often more susceptible to hollow spots than hulls.