Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.
A hydraulic steering ram at the rudder is designed to control up to two rudders simultaneously. Most systems uses two reservoirs (one at the helm and one at the rudder) and pressurised hydraulic lines (filled with oil) to convert steering wheel turns to movements of the hydraulic steering ram.
Check for leaks paying attention to the seals on the ram and helm unit. Flexible hydraulic hoses are considered to have a 10 year service life from date of manufacture (printed on the hose) – in good condition they do last much longer. Make sure the flexible hoses have no dry rot or cracking. Check fittings and connections on all the tubing for leaks as well. Some systems use metal tubing as this does not give the helm a spongy feel. Follow the tubing throughout checking for corrosion or damage. Pay particular attention where tubing passes through bulkheads for chafe and corrosion. If the system has a pressure gauge (usually on the reservoir) check the fluid level and pressure.
Spin the wheel hard over and count the turns, note any noise, if it is noisy or there are an excessive number of turns there may be air in the system. Oil leaks leading to air in the system are the main cause of problems on hydraulic systems. Small leaks can be handled by topping up the reservoir until servicing can done. Any air in the system will cause the steering to feel spongy or may fail altogether. To test for air, put the wheel hard over in both directions, if it bounces back when released, thats the indication of trapped air.
Bleeding air from the system involves filling the reservoirs. Close any cylinder bypass lines, turn the wheel to bleed air from the cylinder bleed screw and repeat the process on opposite lock. Some air may migrate up through the system to the top reservoir – then top up. Small powerboats can utilize a power steering pump mounted on the engine. Filled with fluid, the pump allows the hydraulic system to work. If engine squeals or tough to turn steering are noted, check the engine mounted pump for low fluid, leaks or a broken drive belt.