Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.

The main issues with a wet exhaust system are: An extra hole in the boat for the seawater intake; a strainer to filter the seawater which can get blocked; and a pump that must be powered and maintained – this is the main source of cooling for the exhaust and the engine.

A clogged thru-hull, strainer, or pump failure, will almost immediately cause high exhaust temperatures that can destroy exhaust hose and fiberglass silencers, and loss of cooling to the engine can cause terminal damage. Many boats include an exhaust temperature alarm and/or cooling water alarm to give a few seconds notice.

Another issue is the potential to flood the engine with seawater when over-cranking. When cranking the engine during starting the seawater pump is filling the exhaust with water – if the engine does not start enough water could back-fill into the turbocharger (if installed), exhaust manifold, or cylinders. Usually there is a valve or plug at the bottom of the silencer – if after 30 seconds of continuous cranking the engine does not start drain the water before attempting to start again. This is especially a concern with generator engines, all of which use wet exhaust systems and usually a high swan-neck.