Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.
If a battery is left flat or partially charged it develops a sludge between the lead plates called ‘Lead Sulphation’, this slows the current flow during recharge. This condition is similar to ‘sludge’ in a water tank which builds the back pressure lessening inward flow. It can render a battery useless, reducing capacity and making it unable to be fully charged.
The action of charging causes loss of water in most batteries; in the case of sealed batteries, if over charged, the loss of water will still take place and permanently damage the battery as it cannot be replaced. Charging and discharging also causes a change in the consistency of the electrolyte. When a battery is charged, acid is produced which is more dense/heavy than the electrolyte. When discharged water is produced which is lighter than the electrolyte. The result is that water floats on the heavier acid – called ‘Acid Stratification’ which increases sulphation. When a battery is recharged to near full the higher voltage causes bubbles of hydrogen and oxygen which slowly move up through the electrolyte and out through the vent plugs. The bubbles movement has the effect of mixing the acid achieving a long battery life as acid stratification is reduced.
When batteries are subjected to normal charge/discharge use, unless subjected to long engine running times or shore power charging, effective higher voltage charging is rarely achieved. The lead sulphate in the plates will harden over time this results in a loss of capacity which is progressive and cumulative and will result in reduced charge voltage – a cycle which reduces the life of the battery.