Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.
Bilge alarms and high-water alarms ideally should have a test button to check they are functional. Catamarans need at least one alarm in each hull and for boats with multiple compartments – a sensor in each compartment is a good idea. Water most often gets inside the boat through faulty through-hull fittings and hoses supplying the engine heat exchanger, air-conditioning system or watermaker. These often develop slowly, of course, if the hull gets holed you usually know it immediately.
Conventional bilge alarms have audible and visible alarms at the navigation or helm station, they are inexpensive. If you own a boat with an enclosed bilge, it should have at least one of these basic alarms. Bilge alarms that can link to your mobile phone are more expensive, but more useful as they will alert you wherever you happen to be. On bigger boats the alarm should be loud enough and near enough to sleeping quarters. Leaks don’t always occur when there is someone at the helm.
High water alarms are typically mounted just above the normal operating level of the automatic float switch for the bilge pump, but below the level of critical components; batteries, starter motor etc. Typically, if water disrupts the sensor for more than 8 seconds the alarm and warning LED will be triggered. Other alarms include a float switch hard-wired to activate a second bilge pump and triggers both visible and audible alarms. Other systems include a test button to assure the system is working and also a muting system to shut off the noise when you go to check on the problem.