Overheating – Two Main Culprits

Typically, anything above 90C is the level of concern, many overheat alarms trigger around 96C. Is the water intake strainer clear? If it is then check the pump impeller, if belt driven check the belt tension. The first main culprit of overheating is if the impeller is damaged, torn or missing blades, these become lodged…

Read More

The Service life of Hoses and Clamps

Rubber hoses harden when exposed to heat, vibration, petrol/diesel and water over time – then they crack or fail. The new problem of fuel additives causes the interior wall of fuel hoses to collapse, cutting off the fuel flow and disabling the boat. Older fuel systems were not built with this in mind. The fuel…

Read More

The Two Most Common Causes of Accidents

Maintaining Proper Lookout Lack of attention, or inattention, is the single greatest cause of accidents. Looking at screens and not keeping watch (looking and listening all around) is the basic cause. Use navigational aids, radio and constantly analyse risk of collision. Talking, texting and general use of phones while boating is the main problem on…

Read More

Quick Pre-Trip Inspection

It does not take long to quick check a small boat before it goes in the water. Before every trip inspect: The engine cooling system The propeller and gearbox The total surface of the transom The anodes The engine oil level and the fluid level of the hydraulic steering system The water-separating fuel filter The…

Read More

Stainless Steel Rust – The Solution

The solution involves removal, cleaning and fully bedding the entire base of the hardware. That is, instead of applying bedding compound only to the areas where fasteners pass through, the whole base area should be liberally bedded with sealant that will both create a watertight seal and exclude water that could migrate.  Exclusion of the water…

Read More

Stainless Steel Rust

Rust stains running across a deck or hull are nothing new. If the staining is occurring adjacent to stainless steel hardware, then the “rust” is often the byproduct of a process known as crevice corrosion, whereby normally passive, corrosion-resistant stainless steel becomes active. The metal is compromised and it is much more insidious as the…

Read More

Lithium-Ion Batteries Continued

Charging a lithium-ion battery creates heat. This heat usually dissipates, however, if something goes wrong, the battery creates heat faster than it can shed it, and this increased heat damages internal components, which in turn creates more heat and pressure. This can continue until there is a critical failure. Most lithium-ion batteries also include a…

Read More

Lithium-ion Batteries

Lithium-ion batteries have the following advantages – an energy density per kilogram up to 7 times more than lead acid batteries; weigh half as much; charge around five times faster; last four times longer, (around 10 years or more). Energy density measures battery energy in proportion to weight [watt-hours per kilogram – Wh/kg]. A measure…

Read More

Gel Batteries

Gel cell batteries are durable, never need refilling, cannot spill acid in your bilge and they do not produce explosive gas. A gel battery is a valve-regulated lead acid battery with an electrolyte together with sulphuric acid combined with silica fumes to create a semi-solid gel. Virtually maintenance free they use one-way valves to allow gasses…

Read More

AGM (Absorbant Glass Matt) Batteries

AGM or absorbent glass mat batteries contain fiberglass mat separators that wick the electrolyte solution between the battery plates. This enables the fiberglass to be saturated with electrolyte in a ‘dry’/suspended state rather than liquid form. As the battery generates power electrolyte is transferred from the glass mat to battery plates. The mat contains enough…

Read More