Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.
During construction strength requires even loading through the use of continuous stringers and full bulkheads, with small access holes away from the edge of the bulkhead. The bulkhead-to-hull connection will be made with doubler plate and fillets, there will also be even loading on the bulkhead. The hull-to-deck connection requires extra support and reinforcement, and the foredeck needs to be strong. If any cabin sole is part of the structure it needs sufficient strength. All welding beams and plates need to line up and be tied in with doubler plates at the terminations. Throughout the hull, deck and skin sudden changes in section should be avoided.
During repairs the above needs to be kept in mind and care taken not to affect the loads on stringers and transverse frames thus producing stress concentrations. If a sole is replaced that is a structural member it needs strong and continuous fastening to the rest of the vessel. Any large holes put in bulkheads for access will weaken the whole area through uneven loading and diminish transverse rigidity – the vessel will need extra external support and chocking to avoid deformation during this repair. The same consideration applies to longitudinal stringers, if they have to be cut or notched, as the load distribution will be discontinuous. Care and consideration are required prior to lifting the vessel for repairs as to the load distribution over the entire vessel and where it requires chocking to support the strains. Consideration is also required for any temporary change in loading brought about by effecting repairs and anticipatory support and chocks put in place.