Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.
Structurally efficient hull shapes are produced only when anticipated loading characteristics are understood. The relationship between shape and stress loads concentrates on the gradual blending of mating surfaces and understanding how loads are distributed.
Longitudinals prevent the hull from flexing up and down, transverse bulkheads and frames resist hull twisting. Both longitudinal and transverse structures are integrated to produce a strong hull. Transverses support the longitudinals and longitudinals support the transverses. Inadequate framing or excessive flexibility indicates insufficient reinforcement. Stringers and bulkheads are weakened by notches and holes which lower the moment of inertia and provide sources of stress. Stringers should be continuous runs tightly bound to the frames and skin. When holes need to be cut they should be near the neutral axis where stress is lowest. Although some flexibility is acceptable, the engine/propulsion requirements must be structurally rigid to avoid damage. Inadequately supported deck weakens the vessel and promotes excess flexibility, the superstructure also needs to be adequately supported. Several structural features have important safety aspects. The collision bulkhead aft of the bow prevents flooding in the event of collision. Likewise the propeller gully contains any flooding from the shaft.
A light skin over a strong framework is the basis of continuity of strength, plus an understanding of how the loads are carried in the hull and deck by the engine, rigging, rudder etc. A surveyor needs to trace the hull and deck reinforcements as much as possible, inspect the hull where bulkheads and ribs connect, look for hull deformation. Another area of high loading is on the bulkheads where longitudinals connect; butt straps and brackets will create problems when not continued through the bulkhead. Unbalanced forces applied to the bulkhead will produce a flexing load on the bulkhead. A good design will extend all stiffening members whether longitudinal or transverse from one side of the hull to another. This is not always done with longitudinals.
Wherever any stiffening member such as bulkheads, ribs, mast supports are terminated, the members should be blended with a large radius and broadened as much as possible with a doubler plate. In this fashion the load can be gradually transmitted through the rest of the structure by distributing it over as much area as possible to reduce stress concentrations. Highly stressed parts such as keel connections, chain plates, mast steps and rudders are highly loaded areas where deformation is a sign that load distribution is not evenly taking place. The mast load needs to be distributed evenly through the keel, or deck if stepped. Where the mast butts up against the hull it produces large localised forces. Support pillars must be broad on all axes to prevent buckling.