Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.

There are three methods to reduce sound.

Absorbers – sound absorption reduces reflected sound inside an enclosed room. Sound waves strike sound absorbing material, the sound wave has an energy conversion of kinetic energy to heat. Typically, sound absorbers are porous materials such as open cell foams or fibres. Placing a face on the material (silver foil) the absorption characteristics of the system will change. Some absorber materials also have a barrier hung in the matrix for added effectiveness.

Barriers – block noise from passing through. The phenomenon of blocking is called transmission loss (TL) reported in decibels (dB), that is noise reduction from one side of a barrier to the other. Typically barriers are air impervious, solid, flexible and relatively heavy.

Damping – is vibration control. Vibrating surfaces act as large speakers, they displace air which creates noise. To convert vibration kinetic energy into heat damping materials (typicaly visco-eleastic) is applied to the vibrating surfaces. Visco-eleastic material has the property of a high loss modulus known as the loss factor. The higher the loss factor, the more efficient it is converting the vibration into heat. It is applied to the flat sides of water/fuel tanks, and prop wash area of the hull.

Remember, structure borne noise will travel along all rigid hard connections until it finds a sympathetic surface to radiate sound. So introduce isolation barriers where practical, on bulkheads, tank surfaces and so on.

Airborne noise will follow any air path until it reflects off a hard surface, so make sure air paths are either sealed or take tortuous routes where the airborne vibration must make turns. Line as much surface area as possible with sound absorbers or absorber/barrier composites.