Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.
Pump impellers come in two basic categories – high volume low pressure impellers and low volume high pressure impellers. Most engine-cooling pumps have a brass cover plate held on with several bolts with a flimsy paper gasket behind – which usually breaks. Removing the screws and cover plate exposes the impeller. If the impeller has been changed regularly, it should just slide off the hardened steel shaft. In many cases, it will need to be pried out with a couple of screwdrivers. Take great care not to damage the outer brass pump housing with the screwdrivers, these housings are soft metal and expensive to replace. Immediately behind the impeller will be a water seal and then a bearing supporting the shaft behind the seal.
Some manufacturers make impeller puller, much like gear puller – they are expensive. Other manufacturers have threaded the end of the impeller. Removing this impeller is by threading-on the right sized bolt, as the bolt is tightened, it backs the impeller out.
A hint when servicing a macerator pump: place plenty of towels or nappies around and under the pump to soak up any “stuff” that may dribble out of the pump.
If you see water dribbling out of the pump body where the shaft enters this is a sure sign that you have to change the water seal, it is also a good reason to replace the bearing and impeller at the same time.
In short: carry at least one impeller, paper gasket, water seal and shaft bearing as spares. Preferably two or three of everything.