Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.

A tiller is basically a handle attached directly to the rudder stock (the post attached to the rudder), allowing the skipper in the cockpit to manually swing the rudder beneath the waterline.

Keeping the steering ‘tight’, means that there is little excess movement between tiller and rudder stock, so the rudder engages as the tiller arm is moved. It is important to monitor the rudder bushings/bearings and pintles (these are the fixed halves of the hinges on which the rudder swings. One half is on the stern post, the other half is on the rudder)). They are needed to be in serviceable condition without wear or the rudder will shudder under way.

Tillers are made of solid wood, laminated wood, composite or metal (or a combination). If laminated (usually glue plywood) check for delamination and weakening. If built of more than one piece, check the fittings and connections to ensure that they are solid.

The rudder should also be considered – If made of fibreglass or wood, water seeping into the core is always a potential worry. If water enters into the rudder, the internal stainless steel parts usually begin to corrode, leading to failure in such a way that the rudder pivots on the stock independent of the tiller. Grounding, and underwater damage can also shock and damage the bearing that surrounds the rudder stock. Check the bearing for damage, wear and lubrication as required.