Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.

Mechanical steering systems, known as manual or push-pull systems have different set-ups – but two main types are divided into power and sail: Sailboats often have a wheel mounted pedestal, inside the pedestal will be a gear (or gears) that control a chain or wire through a 90-degree pulley system to the rudderstock. A set-up with bearings and stops will surround the rudderstock and will allow adjustments to the cables that control the rudder movement. Stops, chain/wire, gears and bearings should be inspected.

On powerboats, mechanical steering uses push-pull cables which connect the steering wheel and helm with the outboard motor or occasionally an inboard. This system provides good handling performance and safe operation for smaller powerboats. Housed behind the instrument panel at the helm, the rack-and-pinion set-up converts the steering wheel movements into push-pull action on the cable. The helm usually has a round gear that holds the turning cable. The cable moves the inboard rudder/tiller or outboard engine via a tilt-tube in response to the steering wheel. Check the tilt-tube: Start by unscrewing the nut that connects the outer sleeve to the tilt tube and remove the cable end in its metal sleeve (if possible). If this proves difficult, or the cable end is not moving, the cable between the rack-and-pinion at helm and the motor may need to be replaced. Different helms have a different number of lock-to-lock turns. More turns means less effort to turn the boat.

If repairs are needed in a mechanical steering system, start at the steering arm (at the motor): Disconnect the steering arm from the cable’s motor/rudder end and turn the steering wheel. If the cable now moves freely, you have an issue with the motor, stern drive unit, or rudder. If the cable does not move at all, but the steering wheel freely moves the problem is most likely at the helm. Next, look at the rudder, stern-drive or outboard: Each should be inspected and greased. Find the grease fitting and add a little grease to see if this will fix it. Do not add too much as you can blow out the seals, depending on the type. If adding grease does not fix the issue, it is time for the boat to come out of the water for inspection and repair.