Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.

The first step in locating a non-obvious bilge leak is to dry the section of bilge where the leak seems to be coming in, then place folded paper towels fore and aft of the area. Then check to see if either towel is damp. If one of the end is wet, then the adjacent bilge area is suspect, meaning you repeat the process there. Work through each of the bilge compartments to locate the one where the water is actually entering.

Once you’ve narrowed it down there are a couple of ways to determine where the water is coming from. 1) dry the bilge and cover it with paper towels, then simply watch to see which ones get wet first. Another is drawing a few lines along both sides of the bilge with washable felt pen or chalk – look for runs, then work your way up the hull until you find the source of the leak.

Finally, if all else fails lift the boat and check the exterior for damage, at which point you can run some fresh water into the bilge and look for wet areas (once the hull is dry).