Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.
Engine water hoses are heavy duty. They run from the seawater through-hull valve to the water pump, then to the heat exchanger, up to the engine’s exhaust. It may appear easier (and cheaper) to install a light duty rubber hose to connect the through-hull valve to the raw-water pump, plumb in a siphon break, and make the connections to a hot engine circulation system. However light duty heater hose, though generally heat resistant and adaptable to high pressure, it is thin and soft. This can cause collapse under the vacuum created by the engines raw water pump and ultimately starve the engine of cooling water. Vibration resistance is also an issue on hoses that run against the engine bed and risers: the engine vibration causes the hose to chafe and wear through.
Good-quality heavy duty marine water hose is thicker than heater hose and reinforced with different synthetic materials in multiple layers. The same hoses used for engine sea water hose are often an appropriate choice for cockpit drains, sink drains, and toilet suction lines: A heavy duty, fabric reinforced rubber should be used after a through-hull valve on all piping, tubing, or hose lines below the maximum heeled waterline. Double hose clamps to be used on all below-the-waterline hose connections.