Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.
Fuel line standards also specify maximum acceptable tolerances between fuel-line hoses and any unions or nipples to which they are clamped; All unions or nipples require a bead, flare, or serration, but no fuel-line can be installed over a pipe thread; and further require a hose clamp that does not “depend solely on the spring tension of the clamp for compressive force” Not all A1 hoses can be clamped/clipped some must be swaged.
Double clamps are required on all fuel-lines each with a minimum band width of 10mm and the clamp must be inside the flare or bead, or fully on serration where provided, and at least (6mm) from the end of the hose.
Fill pipes are required to have a minimum 35mm internal diameter and vent pipes a minimum 13mm inside diameter. They must be self-draining – that is, drain into the tank and not hold fuel in-situ.