Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.

Plate Bending by Line Heating – Shipbuilding bow and stern shell plates are among the most challenging parts of a hull to form because they require complex double curvature. Line heating provides a controlled method of producing these shapes by using localised thermal expansion followed by permanent shrinkage during cooling.
The principle is simple, but achieving the correct 3D geometry requires considerable skill. Research and shipyard automation experience show that the result depends not only on temperature, but also on the location and direction of heating lines, heat input, travel speed, existing plate curvature, plate support, and heating sequence.
For bow shell plate forming, some key lessons are: Heating-line planning comes first. Heating lines should be determined from the required final curvature rather than applied uniformly across the plate; Local heating produces both out-of-plane bending and in-plane shrinkage. Their combined effect creates the required shell geometry; Complex bow plates may require heating on both front and rear surfaces, depending on the required inherent deformation; Shape should be checked progressively against templates/reference geometry. Correction becomes more difficult when excessive curvature has already been introduced; Heat input, torch travel speed and heating-line arrangement must be controlled consistently; simply adding more heat is not a reliable forming method; Proper plate support is also important. Research-based automated systems use adjustable support arrangements while applying calculated heating paths; The objective is progressive, predictable forming with minimum rework, rather than forming by repeated trial-and-error heating.

Developing standardized heating maps and sequences for repetitive bow-unit shell plates could help reduce dependency on individual skill, improve dimensional accuracy, shorten forming time and minimize subsequent fairing/rework.


Reference: Tango, Ishiyama & Suzuki, IHIMU-α – A Fully Automated Steel Plate Bending System 

View image