Keith Butterfield, Yacht and Marine Surveyor. Costa del Sol, Spain.
Look for embossed (raised) hallmark on the chain’s links; if necessary, get in touch with the manufacturer to help identification. If the hallmark is indented, or missing, this indicates it not made to a recognised Standard – its use in anchoring is questionable.
When picking a chain choose its strength based on the loads the boat will develop in the harshest conditions in which it might be anchored; Work Load Limits (WLL) are the figures to use. (See Load Table above: Part 3)
When used independent of a windlass, chain from any Standard is used as long as it has the minimum WLL required of it. On the other hand, though the differences between ISO, NACM and Metric chain may seem insignificant, these differences can be critical if a windlass is used. In either case, first choose the chain based on required strength, and then match a windlass to the chain. If the windlass code is absent or is not clear the windlass will need to have various chains trial-fitted until the correct chain is identified.
One approach is to remove the gypsy from the windlass and take it to where various chains can be trial-fit. Another option is to order short samples of various chains from a supplier. Or send the gypsy to a supplier for trial-fitting.
Adequateness – If an existing windlass cannot be fitted with a gypsy that will handle chain of sufficient strength, the choice is to replace the windlass with a model that has a suitable gypsy, or plan on retrieving the chain by hand. Choose chain that has more than an adequate Work Load Limit (WLL), and if a windlass will be involved, chose a windlass that has a gypsy designed to work with that chain.